Hebei Cangzhou Tianxiang Tile Press Co., Ltd.

Hydraulic arching machine
1. Technical parameters of hydraulic arching machine
, equipment installation dimensions
, feeding plate thickness
, feeding width
, effective plate width
, Motor power
, Electric control system The whole machine adopts industrial computer control and inverter control
, Working speed/
, Roll material of tile press: Steel surface is plated with hard chromium, hardness
, Number of forming rows
2.
The production process of tile press equipment. During the production process, tile press equipment will inevitably have problems of one kind or another. The most common one is the deviation of the color steel plate. Once misalignment occurs, it will affect the production efficiency and product qualification rate of the machinery, so we must know how to correct these errors. After a long period of research and exploration, we have come up with a method to adjust this problem. If the equipment If the board runs to the right, you need to use an iron block to pad the left corner, or flatten the roller on the right. The roller on the top should be in line with the roller on the bottom. Consistent, if the top is flattened, the bottom should also be flattened, and the uniform and symmetrical roller cannot be changed. If it still doesn't work, first adjust the four equal corners of the front and rear rows of the color steel tile press from the main frame to the upper end of the bottom shaft to the same height, and then find a line from the first row to the last row. Straighten it, check whether the lower shaft is on a horizontal line, and adjust the left and right sides of the lower shaft to be horizontal. Find the symmetry points for the first and last rows of the color steel tile equipment, then tighten the lock nuts on both sides, draw a straight line forward and backward at the center of the middle runner, and adjust the gap between the upper and lower shafts. The machine can be adjusted along a straight line. In fact, the remedy for board deviation requires long-term production and testing. Different deviation directions have different remedies, but one thing to note is that whether it is a mechanical roller or other parts, both sides need to be aligned. Only two sides Only by alignment can we maintain symmetry and the shape of the product will be regular.