Hebei Cangzhou Tianxiang Tile Press Co., Ltd.

Duplicate steel hydraulic shearing hydraulic shearing machine
,
Equipment length
, width
, height
Equipment power
br/>KW, hydraulic station power
KW
The rollers are made of bearing steel
, annealed after forging
The base is made of
I-beam
The lower five There are four levels of leveling to ensure smoothness
The two-step forming method is used to ensure the squareness and right angles of the product. It can be made in any size
Thickness of rolled material
.(
Also available Design the thickness according to user requirements
)
The width of the rolled section steel
The width of the rolling section is
Rolling speed
Using a new butt-type adjusting steel sleeve, which is simple, fast and strong
The equipment and production
The profiled steel is square and has the fastest adjustment speed, fastest punching, and fastest cutting in the same industry
. Song Dynasty
) 2. Straightening principles and work processes of the tile press
) During straightening, the profile will move from up, down, left, and right, which requires a very loose gap between the straightening mechanism and the profile. There can be a certain gap between the straightening mechanism and the up, down, left, and right appearance of the profile. The gap The size is between .mm. If deformation occurs during straightening and twisting, the gap can be smaller.
) When straightening the profile, it is not possible to come into contact with both the profile appearance and the straightening mechanism. However, the contact with the straightening mechanism is very important in and around the parts where the profile bends and deforms. To prevent the profile from deforming, the arc radius of the straightening mechanism's outline must match the arc of the profile section.
) For profiles with defects such as side bending and warping, apply enough pressure in the opposite direction through the straightening mechanism to cause it to deform for a long time. If the amount of deformation in the opposite direction is appropriate, After rebounding, the profile can be completely straightened. If the formed profile is twisted and bent in one direction, the straightening machine must rotate the profile in the opposite direction, resulting in long-term plastic deformation. If If the rotation angle is appropriate, the profile will not be distorted after rebounding. This is the main principle of straightening the color steel tile press
) Work flow of the tile press
) Roller pressing department It is powered by an electric motor, and the chain drives each roller to roll with each other and bear different forces. In the pressing part, the hydraulic cylinder drives the mold to move up and down, which can make the color steel plate press out regular knots, shaped like tiles, and then sheared. Under the action of the cutter, cut into appropriate sizes as required
)