Technical explanation and maintenance of the tile press, and debugging methods for the deflection of the press plate of the tile press, such as the plate running to the right, padding the left corner (feeding rack), or falling on the right bottom level
, the first row and the last of the equipment Find the center of one row, then tighten the lock nuts on both sides, draw a straight line in front and behind the center of the middle wheel, adjust the gap between the upper and lower shafts, and then adjust the machine along the straight line
br/> First, make the four corners of the front and back rows of the machine the same height from the main frame to the upper end of the bottom shaft, then find a line to straighten it from the first row to the last row
Check it, and then Check whether the shaft is in a straight line, and adjust the left and right sides of the lower shaft to be horizontal
Maintenance of tile press equipment
It is prohibited for anyone who does not understand the structure, performance and operating procedures of the tile press to start the machine.
It is strictly prohibited to work beyond the minimum closing height, that is, the minimum distance mm from the bottom of the upper sliding box to all working surfaces requires the height after the upper and lower molds are closed, plus the thickness of the upper and lower backing plates plus the thickness of the tiles , is not allowed to exceed mm. When manufacturing molds, the design should be based on this requirement to avoid machine tool accidents. Always pay attention to the height of the lubricating oil in the sliding box and the body on both sides.
The equipment should be wiped frequently to keep it clean, and no mud or water should be allowed
News